Open bag packaging machineVery mysterious to most people, because we don't have much contact with it, it is a relatively complicated device. Some people only come to debug it. This is also the reason why many manufacturers do not maintain the bag opening packaging machine in place. In fact, the maintenance of the bag opening packaging machine is not difficult. Let’s take a look at the open packaging machine after use. How to maintain it.
1. The unpacking machine must check the machine parts regularly, at least once a month, check the flexible rotation and wear of the worm gear, worm, lubricating block bolts, bearings and other moving parts. If any defects are found, they should be repaired in time and must not be used forcibly.
2. This machine should be used in a dry and clean room, and should not be recycled in an atmosphere containing acid and other corrosive gases.
3. After opening the pocket packaging machine or stop it after use, take out the rotating drum to clean and brush off the remaining powder in the barrel, and then pack it for next use.
4. When the roller rotates back and forth during the working process, please adjust the M10 screw on the front bearing screw to an appropriate position. For the movement of the gear shaft, adjust the M10 screw bearing bracket on the back to the proper position, adjust the gap, the bearing can not make noise, and the handle pulley is properly tightened. If it is too tight or too loose, it will cause damage to the machine.
5. If the machine cannot be used for a long time, the entire machine must be wiped and cleaned, and the smooth surface of the machine must be coated with anti-rust oil and covered with a cloth.
The above are the maintenance items for using the open-mouth bag packaging machine. As long as you learn these little common sense, you can maintain the machine in order to extend the service life of the machine.