Big bag packaging machineHow to deal with leaky packaging design bags? Common faults of packaging machines are more likely to occur because the volumetric packaging design of packaging design is not very good. There are many reasons for interfering with this problem:
1. The status of the packaging design volume. The packaging design volume is not acceptable, and it is not produced by a reliable manufacturer. The probability of poor packaging design caused by this problem is 97.35%.
2. The packaging design volume has no effective packaging design, which can be divided into two situations. One is that the packaging design volume is not in the normal way, such as the reverse packaging design, if there is no winding shaft seal packing, the fixed packaging design spiral spring is too tight; The second type is wrapping, but the edges are wrinkled, so the wrapping is prone to heating at the edges, causing poor wrapping.
Repair method: the hemming only needs to be rolled flat.
2. Motor condition, the packaging machine is likely to have the upper (lower) motor not rotating.
Maintenance countermeasures:
(1) When the packaging machine shaft is hot, use a dry steel wire ball to clean the thermoplastic;
(2) The encapsulation cannot be sealed;
Maintenance countermeasures: find out whether the working pressure is inside or outside, and then tighten the opposite screws (too tight screws will cause the bag to run away, it is recommended to give priority to), the heating tube is also likely to be broken and edge sealing may occur.
Big bag packaging machine
3. The packaging design is irregular or wrinkled;
Maintenance countermeasures: look for the sealing edge or sealing, use the inner edge or edge, then loosen the surface net, take out the spring in the surface net, and then install it again;
Maintenance countermeasures: adjust packaging design temperature;
Conclusion: The packaging design status of the big bag packaging machine is mainly the packaging design volume status. When adjusting, adjust the temperature first, and then adjust other temperatures.
