How to debug the ton bag packaging machine? After checking the accuracy of the sensor cable, turn on the power supply of the control cabinet and warm it up for 15 minutes before debugging. Next, briefly introduce the weighing and debugging method of the ton bag packaging machine.
(1) Eccentric load adjustment
Place the 10kg standard weights on the two bearing cores of the weighing bucket. When the weighing display shows "positive difference", the sensor output should be adjusted to the lower position; when the weighing display shows "negative difference", the sensor output should be adjusted to the raising position. =
(2) Weighing adjustment
Perform weighing adjustment according to the calibration steps in the manual of the weighing display controller. During the test, increase the standard weights in the order of 0kg, 40kg, 70kg, 90kg, 100kg from 0 to the highest point, and the error values shall not exceed 10g, 20g, 35g, 45g, 50g; from the larger From the value to 0, gradually reduce the standard weights in the order of 100kg, 90kg, 70kg, 40kg, 0kg, and the error value does not exceed the respective tolerance; repeat the test at the two quantitative points of 40kg and 100kg, each weighing Focus on doing it 3 times, each time the error value does not exceed their respective tolerances.
(3) Parameter setting
There are many parameters to be set for quantitative packaging scales. Next, we will briefly introduce the more commonly used core parameters as an example:
a. The quantitative value of the weighing display controller can be set to a quantitative target value, such as 90kg.
b. Fast increase lead and slow increase lead. When the weight> (preset value)-(fast feed advance), the fast feed is suspended and switched to slow feed; when the weight> (preset value)-(slow feed advance), the discharging is suspended .
