How to adjust the ton bag packaging machine? First check that the sensor connection line is correct, turn on the power supply of the control cabinet host and warm up for 15 minutes, then you can adjust. Next, we will introduce in detail the weighing adjustment method of the ton bag packaging machine.
1. Partial load adjustment
Place the 10kg standard weights on the two weights of the weighing bucket. When the weighing display shows "positive difference", the sensor output should be adjusted to the lower position; when the weighing display shows "negative difference", the sensor output should be adjusted to the enhanced position. =
2. Weighing adjustment
Perform the weighing adjustment according to the calibration steps of the ton bag packaging machine weighing display controller manual. During the calibration, the standard weights are increased in the order of 0kg, 40kg, 70kg, 90kg, and 100kg from 0 to the maximum value. The deviation shall not exceed 10g, 20g, 35g, 45g, 50g respectively; from the larger value The standard weights are gradually reduced in the order of 100kg, 90kg, 70kg, 40kg, and 0kg between 0 o'clock, and the deviation shall not exceed the respective tolerance; repeat the repeatability check at the two quantitative analysis points of 40kg and 100kg, each scale Focus on doing a good job 3 times, each time the deviation should not exceed their respective tolerances.
3. Main parameter setting
There are many main parameters that need to be set up for the ton bag packaging machine. Next, taking common important parameters as an example, the detailed introduction is as follows:
(1) The quantitative analysis value of the weighing display controller can be set to the quantitative analysis target value, such as 90kg.
(2) Fast increase lead and slow increase lead. When the net weight> (preset value)-(fast feed advance), the fast feed is suspended and switched to slow feed; when the net weight> (preset value)-(slow feed advance), the feeding is suspended.
