As for the packaging scale, I believe all my friends are familiar with it. With the needs of social development, our products have gradually integrated into the main industries, but maintenance work must be carried out when using the products to ensure the normal use of the products. The following editor will give you an introduction to the maintenance and maintenance of this product.
1. Like other packaging machinery, packaging equipment also needs regular maintenance and cleaning. When cleaning, the machine should be turned off. The surface, bottom plate and lower mold slide plate, groove, upper mold inner pressure plate and positioning rod must be cleaned one by one. The entire machine must be used. Keep it clean and hygienic.
2. The operation must be standardized: each time you run, you must press the power, turn on the power switch, the indicator light is on, and the thermostat is set to a predetermined temperature, etc. Perform correct operation steps to ensure the stability of the packaging scale and the normal operation of the machine. Service life.
3. The troubleshooting method of the seal failure is not strong: the cause of the failure is the improper pressure of the cold-pressed rubber wheel, the heat sealing speed is too fast, the heat sealing temperature is insufficient, and the quality of the heat sealing film is defective. In this case, you can appropriately increase the heat-sealing temperature, then reduce the heat-sealing speed, and at the same time increase the pressure of the cold-pressed rubber wheel.
4. Deal with the display failure of the thermometer: The main reason for the failure of the packaging scale is that the thermometer is broken and must be repaired; the mechanical reason is that the heat-sealing pressure is uneven, and only the pressure spring of the heat-sealing knife needs to be adjusted to keep the pressure consistent. One of the reasons is that the heat sealing quality of the composite material itself is not good, and the heat sealing coefficient changes, resulting in inconsistent temperature.